Why This Happens in Pflugerville
Hard water is the most common reason faucets fail here well before they should. Mineral buildup inside a cartridge or valve seat causes the drip that won't stop even after the handle is fully closed. It's a mechanical wear issue rather than a sign the whole fixture needs replacing.
In a Highland Park kitchen with years of daily use or a newer Blackhawk bathroom, a dripping faucet is almost always a worn cartridge or seat. Hard water speeds up that wear.
How to Tell You Need This
Persistent Dripping
A drip that continues even with the handle fully closed points to a worn cartridge, washer, or valve seat.
Low Water Pressure at One Fixture
Reduced flow at a single faucet, while others run normally, usually means a clogged aerator or supply line restriction, not a house-wide pressure issue.
Handle That's Hard to Turn
A stiff or loose handle often means the cartridge inside has worn down and needs replacing.
Leaking at the Base
Water pooling around the faucet base is usually a worn O-ring, not the faucet body itself.
Plumbing Emergency: Burst Supply Line Or Valve
A failed supply line can put a lot of water on a floor in minutes. These steps buy time until we arrive.
Find the fixture shutoff
Look under the sink for the small oval knobs and turn them clockwise. That isolates the faucet only.
Use the main if the stop fails
Old stops can seize or leak. If the fixture valve will not close, shut the main valve at the house.
Open a low faucet
Open a tub or outdoor faucet to drain pressure from the lines. Less pressure means less left to spill.
Empty the cabinet
Pull out cleaners and stored items, mop the base, and call our 24/7 line. Please do not force a corroded valve.
Our Faucet & Sink Repair Process
We match the internal cartridge, washer, or valve stem to the specific faucet brand and model rather than assuming a generic part will fit. Mismatched parts are the most common reason a DIY faucet repair fails within a few weeks.
For a leak under the sink itself, we check the supply lines and P-trap connections, which loosen over time from normal use and temperature changes, and are often the actual source of a leak that looks like it's coming from the faucet.
Which Option Fits Your Situation
Most faucet problems are a repair, not a replacement, unless the fixture itself is failing structurally.
Repair the Fixture
- Fixes a worn cartridge, washer, or valve seat.
- Matches parts to the specific faucet model.
- Lower cost than replacement.
- Makes sense for a fixture you like the look of.
Replace the Fixture
- Makes sense if the faucet body itself is corroded.
- Better fit for discontinued models with no parts available.
- Opportunity to upgrade finish or features.
- Needed if repeated repairs haven't resolved the issue.
What Determines the Price
Faucet and sink repair pricing depends on the specific part that's failed and whether it's a standard or specialty fixture.
A worn faucet part is routine wear and isn't covered by homeowners insurance, though water damage from a sudden supply line failure sometimes is. Want your real number? Call (512) 737-6168.
The same worn-cartridge pattern that causes a dripping faucet often shows up in a running or leaking toilet, covered on the toilet repair and installation page. If the leak is actually at a shower valve rather than a sink faucet, that's a related but distinct fix detailed on the shower and bathtub installation page.
A leaking connection under the kitchen sink is sometimes actually the garbage disposal rather than the faucet itself. We handle the same repairs for Round Rock homeowners.
Fixture And Valve Problems Callers Report
Fixture calls range from a slow drip to a spraying valve. Here is how we sort them.
Burst or seized supply valves
Old stops can crack, seize or spray. We replace the valve and the supply line together so the same failure does not come back.
Dripping faucets and worn cartridges
A drip usually comes from a worn cartridge, seat or washer. We repair what is worn and replace the fixture only when it is past saving.
Leaking tub and shower valves
A shower valve or tub faucet that leaks inside the wall needs prompt attention. We confirm the source before any wall is opened.
Outdoor spigots and hose bibs
A spigot that drips or sprays behind the handle can waste water and damage siding. We repair or replace it.
Utility and laundry sink leaks
Leaks under a utility sink or behind a washer often come from the supply valve or hose. We replace the failed part and test the connection.
Frequently Asked Questions
Why does my faucet still drip after I replaced the washer myself?
A mismatched or incorrectly seated part is the most common reason a DIY faucet repair doesn't hold. Matching the exact cartridge to the model usually resolves it.
Can you match a discontinued faucet model?
In most cases yes, through the manufacturer's parts catalog or a compatible aftermarket cartridge.
Is low pressure at one faucet a house-wide problem?
Not usually. If other fixtures run normally, it's almost always isolated to that fixture's aerator or supply line.
Do you repair kitchen and bathroom sinks the same way?
The diagnostic approach is the same, though kitchen faucets see more wear from daily use and fail somewhat sooner.
Can a worn faucet actually waste a lot of water?
Yes, even a slow drip can waste over a thousand gallons a year, which shows up as a real difference on the water bill.
Do you handle burst supply valves at night?
Yes. Failed supply valves and braided lines are a regular reason for emergency calls, and our line is answered 24/7.
Can you repair a leaking washing machine valve?
Yes. We replace failed washer shutoff valves and hoses and test the connection for leaks.
Do you install new outdoor faucets?
Yes. We can add or replace outdoor faucets and help you prepare them for a freeze.
Still have a question about Faucet & Sink Repair in Pflugerville? Call (512) 737-6168 and we'll answer it directly.
